1. Peel off the sticky tape attached to the lamp cap, which ensures that the cap is tightened to the
lamp base during shipping.
2. Insert the lamp cable on the top of the headrest part into the socket of the lamp cap on the
illumination part.
3. Connect the two plugs below the headrest part with the corresponding output socket of the
power box.
4.Insert the plug of the input power cable into the input socket od the power box。
5. Remove the cable clips from the bottom of the work table with screw driver and wrap the
output and input cables respectively.
3.9 Assembling the chin-rest paper
1. Pull out the two fixing pins from the chin-rest.
2. Get rid of the paper package and let the pins go through its holes.
3. Insert the fixing pins into the hole again.
3.10 Checking procedure after assembling
1 Power plug
This instrument supplies a 3-wire cable. Please select a proper power socket as matched. Ensure
that the instrument is grounded well.
2 The power box and the illumination part
1. When the main power switch of the power box is placed at ‘I’, it turns on, and ‘O’ for turn off.
The main power switch should be set at the ‘O’ position before connecting the input cable with the
power socket.
2. Turn on the main power switch, and the pilot lamp will be lighted. Open the slit width control
knob to examine the illumination.
3. Rotate the brightness control switch respectively from left to right and the brightness should be
changed accordingly.
4. Check the fixation target device to confirm it islighted
5. Check whether all those moveable parts such as aperture and slit height control knob, filter
selection lever, and magnification changer lever etc. could be operated freely.
6. After examining, turn off the main power. Cover the instrument with the dust-proof cover after
the lamp cap has been cool.
